== >> Fujitsu Devices << == === Interpretation of S.M.A.R.T. Attributes === || '''Device Model''' || '''Attributes ID#''' || '''Attributes Name''' || '''Special''' || '''Description''' || || || 1 || Raw Read Error Rate || || Frequency of errors while reading raw data from a disk. || || || 2 || Throughput Performance || || Average efficiency of a hard disk. || || || 3 || Spin Up Time || || Time needed by spindle to spin-up. || || || 4 || Start/Stop Count || || Number of start/stop cycles of spindle. || || || 5 || Reallocated Sector Count || || Quantity of remapped sectors. || || || 6 || Start/Stop Count || || Number of start/stop cycles of spindle. || || || 7 || Seek Error Rate || || Frequency of errors appearance while positioning. || || || 8 || Seek Time Performance || || The average efficiency of operations while positioning. || || || '''9''' || '''Power-On Hours Count''' || (!) || Quantity of elapsed hours in the switched-on state. || || not all (which?) || |||||| ''Some models of Fujitsu disks use Attribute 9 to store the power-on disk lifetime in seconds. In that case, use the: {{'-v 9,seconds'}} option to correctly display hours, minutes and seconds.'' || || || 10 || Spin-up Retry Count || || Number of retry attempts, that were needed to reach the operational speed of the spindle. || || || 11 || Calibration Retry Count || || Number of attempts to calibrate a drive. || || || 12 || Power Cycle Count || || Number of complete power on/off cycles of hard disk. || || || 13 || Soft Read Error Rate || || Frequency of program errors appearance while reading data from a disk. || || || 192 || Power-Off Retract Cycle || || Emergency Retract Cycle Count || || || 193 || Load/Unload Cycle Count || || Number of cycles into Landing Zone position. || || not all (which?) || 194 || HDA Temperature || || Temperature of a Hard Disk Assembly. || || || 195 || Hardware ECC Recovered || || ECC On The Fly Count || || not all (which?) || 196 || Reallocated Event Count || || Number of remap operations. That means replacing a bad sector by one from the spare area. || || || 197 || Current Pending Sector Count || || Current number of unstable sectors (waiting for remapping). || || || 198 || Offline Scan Uncorrectable Count || || Number of uncorrected errors. || || not all (which?) || 199 || UltraDMA CRC Error Rate || || Total number of errors CRC during UltraDMA mode. || || '''' || 200 || Write Error Rate || || Number of errors while writing to disk (or) flying height (?) (Western Digital: Multi Zone Error Rate). || || '''' || 201 || Soft Read Error Rate || || Frequency of program errors appearance while reading data from a disk. || || '''' || 202 || Data Address Mark Errors || || Number of Data Address Mark (DAM) errors (or) vendor-specific. || || '''' || 203 || Run Out Cancel || || Number of the ECC errors (Maxtor: ECC Errors). || || '''' || 204 || Soft ECC Correction || || Quantity of errors corrected by software ECC. || || '''' || 205 || Thermal Asperity Rate (TAR) || || Frequency of the thermal asperity errors. || || '''' || 206 || Flying Height || || The height of the disk heads above the disk surface. || || '''' || 207 || Spin High Current || || Amount of high current used to spin up the drive. || || '''' || 208 || Spin Buzz || || Number of buzz routines to spin up the drive. || || '''' || 209 || Offline Seek Performance || || Drive's seek performance during offline operations. (Relation to Seek Time Performance - #8?) || || '''' || 220 || Disk Shift || || Shift of disk is possible as a result of strong shock loading in the store, as a result of it's falling or for other reasons (sometimes: Temperature) || || '''' || 221 || G-Sense Error Rate || || Frequency of mistakes as a result of impact loads as detected by a shock sensor(?). || || '''' || 222 || Loaded Hours || || Number of hours in general operational state. || || '''' || 223 || Load/Unload Retry Count || || Loading on drive caused by numerous recurrences of operations, like reading, recording, positioning of heads, etc. || || '''' || 224 || Load Friction || || Load on drive caused by friction in mechanical parts of the store. || || '''' || 225 || Load/Unload Cycle Count || || Number of cycles into Landing Zone position. || || '''' || 226 || Load-in Time || || General time of loading for drive. || || '''' || 227 || Torque Amplification Count || || Quantity efforts of the rotating moment of a drive. || || '''' || 228 || Power-Off Retract Cycle || || Number of power-off cycles (Fujitsu: Emergency Retract Cycle Count). || || '''' || 230 || GMR Head Amplitude || || Amplitude of heads trembling (GMR-head) in running mode. || || '''' || 231 || Temperature || || Temperature of a drive. || || '''' || 240 || Head Flying Hours || || Time while head is positioning. || || '''' || 250 || Read Error Retry Rate || || Number of errors while reading from a disk. || '''References:''' http://www.ariolic.com/activesmart/smart-attributes/