Drive not in Database - WDC WD140EDFZ

[bassclef]

White label drive in external USB case.

smartctl 7.1 2019-12-30 r5022 [Darwin 19.6.0 x86_64] (local build)
Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org

=== START OF INFORMATION SECTION ===
Device Model:     WDC WD140EDFZ-11A0VA0
Firmware Version: 81.00A81
User Capacity:    14,000,519,643,136 bytes [14.0 TB]
Sector Sizes:     512 bytes logical, 4096 bytes physical
Rotation Rate:    5400 rpm
Form Factor:      3.5 inches
Device is:        Not in smartctl database [for details use: -P showall]
ATA Version is:   ACS-2, ATA8-ACS T13/1699-D revision 4
SATA Version is:  SATA 3.2, 6.0 Gb/s (current: 6.0 Gb/s)
Local Time is:    Fri Dec 18 18:38:35 2020 GMT
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
AAM feature is:   Unavailable
APM feature is:   Disabled
Rd look-ahead is: Enabled
Write cache is:   Enabled
DSN feature is:   Unavailable
ATA Security is:  Disabled, NOT FROZEN [SEC1]
Wt Cache Reorder: Unknown

=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED

General SMART Values:
Offline data collection status:  (0x80)	Offline data collection activity
					was never started.
					Auto Offline Data Collection: Enabled.
Self-test execution status:      (   0)	The previous self-test routine completed
					without error or no self-test has ever 
					been run.
Total time to complete Offline 
data collection: 		(  101) seconds.
Offline data collection
capabilities: 			 (0x5b) SMART execute Offline immediate.
					Auto Offline data collection on/off support.
					Suspend Offline collection upon new
					command.
					Offline surface scan supported.
					Self-test supported.
					No Conveyance Self-test supported.
					Selective Self-test supported.
SMART capabilities:            (0x0003)	Saves SMART data before entering
					power-saving mode.
					Supports SMART auto save timer.
Error logging capability:        (0x01)	Error logging supported.
					General Purpose Logging supported.
Short self-test routine 
recommended polling time: 	 (   2) minutes.
Extended self-test routine
recommended polling time: 	 (1339) minutes.
SCT capabilities: 	       (0x003d)	SCT Status supported.
					SCT Error Recovery Control supported.
					SCT Feature Control supported.
					SCT Data Table supported.

SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME          FLAGS    VALUE WORST THRESH FAIL RAW_VALUE
  1 Raw_Read_Error_Rate     PO-R--   100   100   001    -    0
  2 Throughput_Performance  --S---   100   100   054    -    0
  3 Spin_Up_Time            POS---   086   086   001    -    238 (Average 340)
  4 Start_Stop_Count        -O--C-   100   100   000    -    10
  5 Reallocated_Sector_Ct   PO--CK   100   100   001    -    0
  7 Seek_Error_Rate         -O-R--   100   100   001    -    0
  8 Seek_Time_Performance   --S---   100   100   020    -    0
  9 Power_On_Hours          -O--C-   100   100   000    -    0
 10 Spin_Retry_Count        -O--C-   100   100   001    -    0
 12 Power_Cycle_Count       -O--CK   100   100   000    -    10
 22 Unknown_Attribute       PO---K   100   100   025    -    100
192 Power-Off_Retract_Count -O--CK   100   100   000    -    10
193 Load_Cycle_Count        -O--C-   100   100   000    -    10
194 Temperature_Celsius     -O----   039   039   000    -    40 (Min/Max 22/40)
196 Reallocated_Event_Count -O--CK   100   100   000    -    0
197 Current_Pending_Sector  -O---K   100   100   000    -    0
198 Offline_Uncorrectable   ---R--   100   100   000    -    0
199 UDMA_CRC_Error_Count    -O-R--   100   100   000    -    0
                            ||||||_ K auto-keep
                            |||||__ C event count
                            ||||___ R error rate
                            |||____ S speed/performance
                            ||_____ O updated online
                            |______ P prefailure warning

ATA_READ_LOG_EXT (addr=0x00:0x00, page=0, n=1) failed: 48-bit ATA commands not implemented
Read GP Log Directory failed

SMART Log Directory Version 1 [multi-sector log support]
Address    Access  R/W   Size  Description
0x00           SL  R/O      1  Log Directory
0x01           SL  R/O      1  Summary SMART error log
0x02           SL  R/O      1  Comprehensive SMART error log
0x04           SL  R/O    255  Device Statistics log
0x06           SL  R/O      1  SMART self-test log
0x09           SL  R/W      1  Selective self-test log
0x30           SL  R/O      9  IDENTIFY DEVICE data log
0x80-0x9f      SL  R/W     16  Host vendor specific log
0xe0           SL  R/W      1  SCT Command/Status
0xe1           SL  R/W      1  SCT Data Transfer

SMART Extended Comprehensive Error Log (GP Log 0x03) not supported

SMART Error Log Version: 1
No Errors Logged

SMART Extended Self-test Log (GP Log 0x07) not supported

SMART Self-test log structure revision number 1
Num  Test_Description    Status                  Remaining  LifeTime(hours)  LBA_of_first_error
# 1  Short offline       Completed without error       00%         0         -

SMART Selective self-test log data structure revision number 1
 SPAN  MIN_LBA  MAX_LBA  CURRENT_TEST_STATUS
    1        0        0  Not_testing
    2        0        0  Not_testing
    3        0        0  Not_testing
    4        0        0  Not_testing
    5        0        0  Not_testing
Selective self-test flags (0x0):
  After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.

SCT Status Version:                  3
SCT Version (vendor specific):       256 (0x0100)
Device State:                        Active (0)
Current Temperature:                    40 Celsius
Power Cycle Min/Max Temperature:     36/40 Celsius
Lifetime    Min/Max Temperature:     22/40 Celsius
Under/Over Temperature Limit Count:   0/0
SMART Status:                        0xc24f (PASSED)
Minimum supported ERC Time Limit:    65 (6.5 seconds)

SCT Temperature History Version:     2
Temperature Sampling Period:         1 minute
Temperature Logging Interval:        1 minute
Min/Max recommended Temperature:      0/65 Celsius
Min/Max Temperature Limit:           -40/70 Celsius
Temperature History Size (Index):    128 (53)

Index    Estimated Time   Temperature Celsius
  54    2020-12-18 16:31     0  -
 ...    ..( 72 skipped).    ..  -
 127    2020-12-18 17:44     0  -
   0    2020-12-18 17:45    24  *****
   1    2020-12-18 17:46    25  ******
   2    2020-12-18 17:47    22  ***
   3    2020-12-18 17:48    24  *****
   4    2020-12-18 17:49    24  *****
   5    2020-12-18 17:50    25  ******
   6    2020-12-18 17:51    25  ******
   7    2020-12-18 17:52    26  *******
   8    2020-12-18 17:53    27  ********
   9    2020-12-18 17:54    27  ********
  10    2020-12-18 17:55    28  *********
  11    2020-12-18 17:56    28  *********
  12    2020-12-18 17:57    29  **********
  13    2020-12-18 17:58    30  ***********
  14    2020-12-18 17:59    30  ***********
  15    2020-12-18 18:00    31  ************
  16    2020-12-18 18:01    31  ************
  17    2020-12-18 18:02    32  *************
  18    2020-12-18 18:03    32  *************
  19    2020-12-18 18:04    32  *************
  20    2020-12-18 18:05    33  **************
  21    2020-12-18 18:06    33  **************
  22    2020-12-18 18:07    34  ***************
 ...    ..(  2 skipped).    ..  ***************
  25    2020-12-18 18:10    34  ***************
  26    2020-12-18 18:11    35  ****************
  27    2020-12-18 18:12    35  ****************
  28    2020-12-18 18:13    36  *****************
  29    2020-12-18 18:14    34  ***************
  30    2020-12-18 18:15    35  ****************
  31    2020-12-18 18:16    35  ****************
  32    2020-12-18 18:17    35  ****************
  33    2020-12-18 18:18    36  *****************
 ...    ..(  4 skipped).    ..  *****************
  38    2020-12-18 18:23    36  *****************
  39    2020-12-18 18:24    37  ******************
  40    2020-12-18 18:25    37  ******************
  41    2020-12-18 18:26    37  ******************
  42    2020-12-18 18:27    38  *******************
 ...    ..(  3 skipped).    ..  *******************
  46    2020-12-18 18:31    38  *******************
  47    2020-12-18 18:32    39  ********************
 ...    ..(  2 skipped).    ..  ********************
  50    2020-12-18 18:35    39  ********************
  51    2020-12-18 18:36    40  *********************
  52    2020-12-18 18:37    40  *********************
  53    2020-12-18 18:38     0  -

SMART WRITE LOG does not return COUNT and LBA_LOW register
SCT (Get) Error Recovery Control command failed

Device Statistics (SMART Log 0x04)
Page  Offset Size        Value Flags Description
ATA_SMART_READ_LOG failed: Undefined error: 0
Read Device Statistics pages 0x00-0x06 failed

Pending Defects log (GP Log 0x0c) not supported

ATA_READ_LOG_EXT (addr=0x11:0x00, page=0, n=1) failed: 48-bit ATA commands not implemented
Read SATA Phy Event Counters failed

[Gabriele Pohl]

drive has been added to the drivedb.h inbetween:

smartctl -B ./drivedb.h -P showall 'WDC WD140EDFZ-11A0VA0'
Drive found in smartmontools Database.  Drive identity strings:
MODEL:              WDC WD140EDFZ-11A0VA0
FIRMWARE:           (any)
match smartmontools Drive Database entry:
MODEL REGEXP:       WDC WD(80|100|120|140)E([MZ]A|DF|DG)Z-.*
FIRMWARE REGEXP:    .*
MODEL FAMILY:       Western Digital Ultrastar He10/12
ATTRIBUTE OPTIONS:  022 Helium_Level

[Christian Franke]

Reopen to change resolution.

[Christian Franke]

r5356, r5361, see ticket #1394.