smartctl 6.5 2016-05-07 r4318 [x86_64-w64-mingw32-win10] (sf-6.5-1) Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: SAMSUNG SSD PM871 2.5 7mm 256GB Serial Number: S1ZTNXAG869209 LU WWN Device Id: 5 002538 d4044d927 Firmware Version: EMT02D0Q User Capacity: 256 060 514 304 bytes [256 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device Form Factor: 2.5 inches Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 4c SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Wed Jan 25 15:01:15 2017 PM SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 0) seconds. Offline data collection capabilities: (0x53) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 133) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 1 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 5 Reallocated_Sector_Ct PO--CK 100 100 010 - 0 12 Power_Cycle_Count PO--CK 099 099 000 - 533 175 Program_Fail_Count_Chip PO--CK 100 100 010 - 0 176 Erase_Fail_Count_Chip PO--CK 100 100 010 - 0 177 Wear_Leveling_Count PO--C- 098 098 005 - 27 178 Used_Rsvd_Blk_Cnt_Chip PO--C- 100 100 010 - 0 179 Used_Rsvd_Blk_Cnt_Tot PO--C- 100 100 010 - 0 180 Unused_Rsvd_Blk_Cnt_Tot PO--C- 100 100 010 - 771 181 Program_Fail_Cnt_Total PO--CK 100 100 010 - 0 182 Erase_Fail_Count_Total PO--CK 100 100 010 - 0 187 Reported_Uncorrect PO--CK 100 100 000 - 0 195 Hardware_ECC_Recovered PO-RC- 200 200 000 - 0 241 Total_LBAs_Written PO--CK 099 099 000 - 6470667811 242 Total_LBAs_Read PO--CK 099 099 000 - 8335143620 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 SATA NCQ Queued Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x13 GPL R/O 1 SATA NCQ Send and Receive log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 2258 - # 2 Short offline Completed without error 00% 2217 - # 3 Short offline Completed without error 00% 2188 - # 4 Short offline Completed without error 00% 2180 - # 5 Extended offline Completed without error 00% 2147 - # 6 Short offline Completed without error 00% 2140 - # 7 Short offline Completed without error 00% 2102 - # 8 Short offline Completed without error 00% 2094 - # 9 Short offline Completed without error 00% 2057 - #10 Short offline Completed without error 00% 1986 - #11 Short offline Completed without error 00% 1949 - #12 Short offline Completed without error 00% 1941 - #13 Short offline Completed without error 00% 1903 - #14 Short offline Completed without error 00% 1895 - #15 Short offline Completed without error 00% 1895 - #16 Short offline Completed without error 00% 1875 - Warning! SMART Selective Self-Test Log Structure error: invalid SMART checksum. SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing 255 0 65535 Read_scanning was never started Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) SCT Support Level: 1 Device State: SCT command executing in background (5) Current Temperature: 45 Celsius Power Cycle Min/Max Temperature: 37/49 Celsius Lifetime Min/Max Temperature: 0/70 Celsius Under/Over Temperature Limit Count: 4294967295/4294901760 SMART Status: 0xffff (Reserved) SCT Temperature History Version: 3 (Unknown, should be 2) Temperature Sampling Period: 1 minute Temperature Logging Interval: 10 minutes Min/Max recommended Temperature: 0/70 Celsius Min/Max Temperature Limit: 0/70 Celsius Temperature History Size (Index): 128 (38) Index Estimated Time Temperature Celsius 39 2017-01-24 17:50 ? - ... ..( 87 skipped). .. - 127 2017-01-25 08:30 ? - 0 2017-01-25 08:40 40 ********************* 1 2017-01-25 08:50 37 ****************** 2 2017-01-25 09:00 38 ******************* 3 2017-01-25 09:10 40 ********************* 4 2017-01-25 09:20 44 ************************* 5 2017-01-25 09:30 42 *********************** 6 2017-01-25 09:40 42 *********************** 7 2017-01-25 09:50 47 **************************** 8 2017-01-25 10:00 46 *************************** 9 2017-01-25 10:10 43 ************************ 10 2017-01-25 10:20 46 *************************** 11 2017-01-25 10:30 48 ***************************** 12 2017-01-25 10:40 48 ***************************** 13 2017-01-25 10:50 46 *************************** 14 2017-01-25 11:00 47 **************************** 15 2017-01-25 11:10 46 *************************** 16 2017-01-25 11:20 46 *************************** 17 2017-01-25 11:30 44 ************************* 18 2017-01-25 11:40 46 *************************** 19 2017-01-25 11:50 47 **************************** 20 2017-01-25 12:00 47 **************************** 21 2017-01-25 12:10 48 ***************************** 22 2017-01-25 12:20 48 ***************************** 23 2017-01-25 12:30 45 ************************** 24 2017-01-25 12:40 44 ************************* 25 2017-01-25 12:50 44 ************************* 26 2017-01-25 13:00 44 ************************* 27 2017-01-25 13:10 42 *********************** 28 2017-01-25 13:20 42 *********************** 29 2017-01-25 13:30 43 ************************ 30 2017-01-25 13:40 44 ************************* 31 2017-01-25 13:50 43 ************************ 32 2017-01-25 14:00 44 ************************* 33 2017-01-25 14:10 46 *************************** 34 2017-01-25 14:20 46 *************************** 35 2017-01-25 14:30 45 ************************** 36 2017-01-25 14:40 49 ****************************** 37 2017-01-25 14:50 49 ****************************** 38 2017-01-25 15:00 45 ************************** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 65535+ Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 3 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0010 2 0 R_ERR response for host-to-device data FIS, non-CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x0013 2 0 R_ERR response for host-to-device non-data FIS, non-CRC