smartctl 6.3 2014-07-26 r3976 [x86_64-linux-3.11.10-21-desktop] (SUSE RPM) Copyright (C) 2002-14, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: WDC WD60EZRX-00MVLB1 Serial Number: WD-WX41D3404227 LU WWN Device Id: 5 0014ee 2b54a4503 Firmware Version: 80.00A80 User Capacity: 6.001.175.126.016 bytes [6,00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5700 rpm Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ACS-2, ACS-3 T13/2161-D revision 3b SATA Version is: SATA 3.1, 6.0 Gb/s (current: 1.5 Gb/s) Local Time is: Mon Oct 13 06:40:07 2014 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x80) Offline data collection activity was never started. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 5024) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 703) minutes. Conveyance self-test routine recommended polling time: ( 5) minutes. SCT capabilities: (0x3035) SCT Status supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 200 200 051 - 0 3 Spin_Up_Time POS--K 100 253 021 - 0 4 Start_Stop_Count -O--CK 100 100 000 - 5 5 Reallocated_Sector_Ct PO--CK 200 200 140 - 0 7 Seek_Error_Rate -OSR-K 100 253 000 - 0 9 Power_On_Hours -O--CK 100 100 000 - 53 10 Spin_Retry_Count -O--CK 100 253 000 - 0 11 Calibration_Retry_Count -O--CK 100 253 000 - 0 12 Power_Cycle_Count -O--CK 100 100 000 - 5 192 Power-Off_Retract_Count -O--CK 200 200 000 - 0 193 Load_Cycle_Count -O--CK 200 200 000 - 59 194 Temperature_Celsius -O---K 127 108 000 - 25 196 Reallocated_Event_Count -O--CK 200 200 000 - 0 197 Current_Pending_Sector -O--CK 200 200 000 - 0 198 Offline_Uncorrectable ----CK 100 253 000 - 0 199 UDMA_CRC_Error_Count -O--CK 200 200 000 - 0 200 Multi_Zone_Error_Rate ---R-- 200 200 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 GPL R/O 6 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa0-0xa7 GPL,SL VS 16 Device vendor specific log 0xa8-0xb6 GPL,SL VS 1 Device vendor specific log 0xb7 GPL,SL VS 40 Device vendor specific log 0xbd GPL,SL VS 1 Device vendor specific log 0xc0 GPL,SL VS 1 Device vendor specific log 0xc1 GPL VS 93 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (6 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 53 - # 2 Short offline Completed without error 00% 46 - # 3 Selective offline Completed without error 00% 45 - # 4 Short offline Completed without error 00% 45 - # 5 Short offline Completed without error 00% 45 - # 6 Selective offline Completed without error 00% 44 - # 7 Extended offline Completed without error 00% 44 - # 8 Selective offline Aborted by host 10% 4 - # 9 Short offline Completed without error 00% 2 - #10 Conveyance offline Completed without error 00% 0 - #11 Short offline Completed without error 00% 0 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 258 (0x0102) SCT Support Level: 1 Device State: Active (0) Current Temperature: 25 Celsius Power Cycle Min/Max Temperature: 25/25 Celsius Lifetime Min/Max Temperature: 23/44 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -41/85 Celsius Temperature History Size (Index): 478 (372) Index Estimated Time Temperature Celsius 373 2014-10-12 22:43 32 ************* 374 2014-10-12 22:44 32 ************* 375 2014-10-12 22:45 32 ************* 376 2014-10-12 22:46 33 ************** ... ..( 3 skipped). .. ************** 380 2014-10-12 22:50 33 ************** 381 2014-10-12 22:51 34 *************** ... ..( 2 skipped). .. *************** 384 2014-10-12 22:54 34 *************** 385 2014-10-12 22:55 35 **************** ... ..( 3 skipped). .. **************** 389 2014-10-12 22:59 35 **************** 390 2014-10-12 23:00 36 ***************** ... ..( 3 skipped). .. ***************** 394 2014-10-12 23:04 36 ***************** 395 2014-10-12 23:05 37 ****************** ... ..( 7 skipped). .. ****************** 403 2014-10-12 23:13 37 ****************** 404 2014-10-12 23:14 38 ******************* ... ..( 7 skipped). .. ******************* 412 2014-10-12 23:22 38 ******************* 413 2014-10-12 23:23 39 ******************** ... ..( 10 skipped). .. ******************** 424 2014-10-12 23:34 39 ******************** 425 2014-10-12 23:35 40 ********************* ... ..( 26 skipped). .. ********************* 452 2014-10-13 00:02 40 ********************* 453 2014-10-13 00:03 41 ********************** ... ..(192 skipped). .. ********************** 168 2014-10-13 03:16 41 ********************** 169 2014-10-13 03:17 40 ********************* ... ..( 8 skipped). .. ********************* 178 2014-10-13 03:26 40 ********************* 179 2014-10-13 03:27 39 ******************** ... ..( 20 skipped). .. ******************** 200 2014-10-13 03:48 39 ******************** 201 2014-10-13 03:49 38 ******************* ... ..( 74 skipped). .. ******************* 276 2014-10-13 05:04 38 ******************* 277 2014-10-13 05:05 37 ****************** ... ..( 82 skipped). .. ****************** 360 2014-10-13 06:28 37 ****************** 361 2014-10-13 06:29 38 ******************* 362 2014-10-13 06:30 ? - 363 2014-10-13 06:31 25 ****** 364 2014-10-13 06:32 26 ******* 365 2014-10-13 06:33 26 ******* 366 2014-10-13 06:34 26 ******* 367 2014-10-13 06:35 27 ******** 368 2014-10-13 06:36 27 ******** 369 2014-10-13 06:37 27 ******** 370 2014-10-13 06:38 ? - 371 2014-10-13 06:39 25 ****** 372 2014-10-13 06:40 25 ****** SCT Error Recovery Control command not supported Device Statistics (GP Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 0 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 1 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x8000 4 65 Vendor specific