smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.10.0-21-amd64] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: SAMSUNG HD161HJ Serial Number: S0V3J9CQ533637 LU WWN Device Id: 5 0000f0 09b533637 Firmware Version: JF100-19 User Capacity: 160,041,885,696 bytes [160 GB] Sector Size: 512 bytes logical/physical Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ATA/ATAPI-7, ATA8-ACS T13/1699-D revision 3b Local Time is: Wed Apr 5 22:32:59 2023 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM feature is: Disabled Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x02) Offline data collection activity was completed without error. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 2964) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 50) minutes. SCT capabilities: (0x003f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-- 100 100 051 - 0 3 Spin_Up_Time POS--- 253 253 025 - 4416 4 Start_Stop_Count -O--CK 099 099 000 - 1209 5 Reallocated_Sector_Ct PO--CK 253 253 010 - 0 7 Seek_Error_Rate POSR-- 253 253 051 - 0 8 Seek_Time_Performance P-S--K 253 253 015 - 0 9 Power_On_Hours -O--CK 100 100 000 - 6201 10 Spin_Retry_Count PO--CK 253 253 051 - 0 11 Calibration_Retry_Count -O--C- 253 253 000 - 0 12 Power_Cycle_Count -O--CK 100 100 000 - 846 13 Read_Soft_Error_Rate -OSR-- 100 100 000 - 5901031 184 End-to-End_Error PO--CK 253 253 099 - 0 187 Reported_Uncorrect -O--CK 253 253 000 - 0 188 Command_Timeout -O--CK 253 253 000 - 0 190 Airflow_Temperature_Cel -O---K 157 112 000 - 27 (Min/Max 13/42) 194 Temperature_Celsius -O---K 148 112 000 - 30 (Min/Max 13/42) 195 Hardware_ECC_Recovered -O-RC- 100 100 000 - 5901031 196 Reallocated_Event_Count -O--CK 253 253 000 - 0 197 Current_Pending_Sector -O--C- 253 253 000 - 0 198 Offline_Uncorrectable ----CK 253 253 000 - 0 199 UDMA_CRC_Error_Count -OSRCK 200 200 000 - 0 200 Multi_Zone_Error_Rate -O-R-- 253 100 000 - 0 201 Soft_Read_Error_Rate -O-R-- 253 100 000 - 0 202 Data_Address_Mark_Errs -O--CK 253 253 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 2 Comprehensive SMART error log 0x03 GPL R/O 2 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (2 sectors) No Errors Logged SMART Extended Self-test Log (GP Log 0x07) not supported SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 6201 - # 2 Short offline Completed without error 00% 6200 - # 3 Short offline Completed without error 00% 6188 - # 4 Extended offline Completed without error 00% 6138 - SMART Selective self-test log data structure revision number 0 Note: revision number not 1 implies that no selective self-test has ever been run SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 30 Celsius Power Cycle Min/Max Temperature: 25/30 Celsius Lifetime Min/Max Temperature: 13/44 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: -4/72 Celsius Min/Max Temperature Limit: -9/77 Celsius Temperature History Size (Index): 128 (92) Index Estimated Time Temperature Celsius 93 2023-04-05 20:25 32 ************* 94 2023-04-05 20:26 32 ************* 95 2023-04-05 20:27 31 ************ 96 2023-04-05 20:28 31 ************ 97 2023-04-05 20:29 30 *********** 98 2023-04-05 20:30 30 *********** 99 2023-04-05 20:31 30 *********** 100 2023-04-05 20:32 29 ********** 101 2023-04-05 20:33 29 ********** 102 2023-04-05 20:34 29 ********** 103 2023-04-05 20:35 28 ********* ... ..( 13 skipped). .. ********* 117 2023-04-05 20:49 28 ********* 118 2023-04-05 20:50 27 ******** ... ..( 18 skipped). .. ******** 9 2023-04-05 21:09 27 ******** 10 2023-04-05 21:10 35 **************** 11 2023-04-05 21:11 13 - 12 2023-04-05 21:12 15 - 13 2023-04-05 21:13 16 - 14 2023-04-05 21:14 18 - 15 2023-04-05 21:15 18 - 16 2023-04-05 21:16 19 - 17 2023-04-05 21:17 20 * 18 2023-04-05 21:18 21 ** 19 2023-04-05 21:19 21 ** 20 2023-04-05 21:20 22 *** 21 2023-04-05 21:21 22 *** 22 2023-04-05 21:22 23 **** 23 2023-04-05 21:23 23 **** 24 2023-04-05 21:24 24 ***** 25 2023-04-05 21:25 24 ***** 26 2023-04-05 21:26 24 ***** 27 2023-04-05 21:27 25 ****** ... ..( 3 skipped). .. ****** 31 2023-04-05 21:31 25 ****** 32 2023-04-05 21:32 26 ******* ... ..( 4 skipped). .. ******* 37 2023-04-05 21:37 26 ******* 38 2023-04-05 21:38 27 ******** ... ..( 19 skipped). .. ******** 58 2023-04-05 21:58 27 ******** 59 2023-04-05 21:59 28 ********* 60 2023-04-05 22:00 35 **************** 61 2023-04-05 22:01 ? - 62 2023-04-05 22:02 ? - 63 2023-04-05 22:03 25 ****** 64 2023-04-05 22:04 25 ****** 65 2023-04-05 22:05 26 ******* 66 2023-04-05 22:06 27 ******** 67 2023-04-05 22:07 26 ******* 68 2023-04-05 22:08 27 ******** 69 2023-04-05 22:09 27 ******** 70 2023-04-05 22:10 27 ******** 71 2023-04-05 22:11 26 ******* 72 2023-04-05 22:12 27 ******** 73 2023-04-05 22:13 28 ********* 74 2023-04-05 22:14 28 ********* 75 2023-04-05 22:15 29 ********** 76 2023-04-05 22:16 29 ********** 77 2023-04-05 22:17 29 ********** 78 2023-04-05 22:18 30 *********** ... ..( 12 skipped). .. *********** 91 2023-04-05 22:31 30 *********** 92 2023-04-05 22:32 33 ************** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 0 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 0 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0010 2 0 R_ERR response for host-to-device data FIS, non-CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x0013 2 0 R_ERR response for host-to-device non-data FIS, non-CRC 0x8001 2 0 Vendor specific