smartctl 6.5 2016-01-24 r4214 [x86_64-linux-5.3.0-24-generic] (local build) Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: WDC WSH722020ALE6L0 Serial Number: 3HG06ERF LU WWN Device Id: 5 000cca 29dc0182f Firmware Version: PCGMT421 User Capacity: 20,000,588,955,648 bytes [20.0 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 3.5 inches Device is: Not in smartctl database [for details use: -P showall] ATA Version is: Unknown(0x0ffc) (unknown minor revision code: 0x009c) SATA Version is: SATA >3.2 (0x1ff), 6.0 Gb/s (current: 3.0 Gb/s) Local Time is: Wed Nov 17 16:52:53 2021 CST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 254 (maximum performance) Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x80) Offline data collection activity was never started. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 101) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: (2340) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 001 - 0 2 Throughput_Performance P-S--- 155 155 054 - 20 3 Spin_Up_Time POS--- 084 084 001 - 329 (Average 330) 4 Start_Stop_Count -O--C- 100 100 000 - 4 5 Reallocated_Sector_Ct PO--CK 100 100 001 - 0 7 Seek_Error_Rate PO-R-- 100 100 001 - 0 8 Seek_Time_Performance P-S--- 140 140 020 - 15 9 Power_On_Hours -O--C- 100 100 000 - 539 10 Spin_Retry_Count PO--C- 100 100 001 - 0 12 Power_Cycle_Count -O--CK 100 100 000 - 4 22 Unknown_Attribute PO---K 100 100 025 - 100 192 Power-Off_Retract_Count -O--CK 100 100 000 - 443 193 Load_Cycle_Count -O--C- 100 100 000 - 443 194 Temperature_Celsius -O---- 066 066 000 - 29 (Min/Max 21/34) 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x04 GPL R/O 256 Device Statistics log 0x04 SL R/O 255 Device Statistics log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x08 GPL R/O 2 Power Conditions log 0x09 SL R/W 1 Selective self-test log 0x0c GPL R/O 30001 Pending Defects log 0x10 GPL R/O 2 SATA NCQ Queued Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x12 GPL R/O 1 SATA NCQ NON-DATA log 0x13 GPL R/O 1 SATA NCQ Send and Receive log 0x15 GPL R/W 1 SATA Rebuild Assist log 0x24 GPL R/O 256 Current Device Internal Status Data log 0x25 GPL R/O 256 Saved Device Internal Status Data log 0x2f GPL - 1 Reserved 0x30 GPL,SL R/O 10 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 538 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) SCT Support Level: 0 Device State: Active (0) Current Temperature: 29 Celsius Power Cycle Min/Max Temperature: 23/29 Celsius Lifetime Min/Max Temperature: 21/34 Celsius Under/Over Temperature Limit Count: 0/0 SMART Status: 0xc24f (PASSED) SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/70 Celsius Temperature History Size (Index): 128 (105) Index Estimated Time Temperature Celsius 106 2021-11-17 14:45 29 ********** ... ..( 4 skipped). .. ********** 111 2021-11-17 14:50 29 ********** 112 2021-11-17 14:51 28 ********* 113 2021-11-17 14:52 28 ********* 114 2021-11-17 14:53 29 ********** ... ..( 2 skipped). .. ********** 117 2021-11-17 14:56 29 ********** 118 2021-11-17 14:57 30 *********** ... ..( 7 skipped). .. *********** 126 2021-11-17 15:05 30 *********** 127 2021-11-17 15:06 29 ********** ... ..( 13 skipped). .. ********** 13 2021-11-17 15:20 29 ********** 14 2021-11-17 15:21 28 ********* 15 2021-11-17 15:22 28 ********* 16 2021-11-17 15:23 29 ********** ... ..( 2 skipped). .. ********** 19 2021-11-17 15:26 29 ********** 20 2021-11-17 15:27 30 *********** ... ..( 7 skipped). .. *********** 28 2021-11-17 15:35 30 *********** 29 2021-11-17 15:36 29 ********** ... ..( 19 skipped). .. ********** 49 2021-11-17 15:56 29 ********** 50 2021-11-17 15:57 30 *********** ... ..( 8 skipped). .. *********** 59 2021-11-17 16:06 30 *********** 60 2021-11-17 16:07 29 ********** ... ..( 17 skipped). .. ********** 78 2021-11-17 16:25 29 ********** 79 2021-11-17 16:26 30 *********** ... ..( 4 skipped). .. *********** 84 2021-11-17 16:31 30 *********** 85 2021-11-17 16:32 23 **** 86 2021-11-17 16:33 24 ***** 87 2021-11-17 16:34 25 ****** 88 2021-11-17 16:35 25 ****** 89 2021-11-17 16:36 26 ******* 90 2021-11-17 16:37 26 ******* 91 2021-11-17 16:38 26 ******* 92 2021-11-17 16:39 27 ******** ... ..( 2 skipped). .. ******** 95 2021-11-17 16:42 27 ******** 96 2021-11-17 16:43 28 ********* 97 2021-11-17 16:44 28 ********* 98 2021-11-17 16:45 29 ********** ... ..( 6 skipped). .. ********** 105 2021-11-17 16:52 29 ********** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 2 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 1 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS