smartctl 7.2 2020-12-30 r5155 [Darwin 18.7.0 x86_64] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: WDC WD80EDAZ-11TA3A0 Firmware Version: 81.00A81 User Capacity: 8,001,563,222,016 bytes [8.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 3.5 inches Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 4 SATA Version is: SATA 3.2, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Sun Feb 28 09:56:25 2021 EST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM feature is: Disabled Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Unknown === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x80) Offline data collection activity was never started. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 87) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 890) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 016 - 0 2 Throughput_Performance --S--- 128 128 054 - 108 3 Spin_Up_Time POS--- 167 167 024 - 453 (Average 520) 4 Start_Stop_Count -O--C- 100 100 000 - 394 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate -O-R-- 100 100 067 - 0 8 Seek_Time_Performance --S--- 128 128 020 - 18 9 Power_On_Hours -O--C- 100 100 000 - 98 10 Spin_Retry_Count -O--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 100 100 000 - 394 192 Power-Off_Retract_Count -O--CK 100 100 000 - 395 193 Load_Cycle_Count -O--C- 100 100 000 - 395 194 Temperature_Celsius -O---- 114 114 000 - 57 (Min/Max 20/61) 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning ATA_READ_LOG_EXT (addr=0x00:0x00, page=0, n=1) failed: 48-bit ATA commands not implemented Read GP Log Directory failed SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x04 SL R/O 255 Device Statistics log 0x06 SL R/O 1 SMART self-test log 0x09 SL R/W 1 Selective self-test log 0x30 SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f SL R/W 16 Host vendor specific log 0xe0 SL R/W 1 SCT Command/Status 0xe1 SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log (GP Log 0x03) not supported SMART Error Log Version: 1 No Errors Logged SMART Extended Self-test Log (GP Log 0x07) not supported SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 98 - # 2 Short offline Completed without error 00% 78 - # 3 Short offline Completed without error 00% 73 - # 4 Short offline Completed without error 00% 39 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 57 Celsius Power Cycle Min/Max Temperature: 55/57 Celsius Lifetime Min/Max Temperature: 20/61 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/65 Celsius Min/Max Temperature Limit: -40/70 Celsius Temperature History Size (Index): 128 (13) Index Estimated Time Temperature Celsius 14 2021-02-28 07:49 51 ******************************** 15 2021-02-28 07:50 51 ******************************** 16 2021-02-28 07:51 52 ********************************* ... ..( 5 skipped). .. ********************************* 22 2021-02-28 07:57 52 ********************************* 23 2021-02-28 07:58 53 ********************************** ... ..( 7 skipped). .. ********************************** 31 2021-02-28 08:06 53 ********************************** 32 2021-02-28 08:07 54 *********************************** ... ..( 6 skipped). .. *********************************** 39 2021-02-28 08:14 54 *********************************** 40 2021-02-28 08:15 55 ************************************ ... ..( 9 skipped). .. ************************************ 50 2021-02-28 08:25 55 ************************************ 51 2021-02-28 08:26 56 ************************************* ... ..( 10 skipped). .. ************************************* 62 2021-02-28 08:37 56 ************************************* 63 2021-02-28 08:38 57 ************************************** ... ..( 2 skipped). .. ************************************** 66 2021-02-28 08:41 57 ************************************** 67 2021-02-28 08:42 42 *********************** 68 2021-02-28 08:43 35 **************** 69 2021-02-28 08:44 28 ********* 70 2021-02-28 08:45 29 ********** 71 2021-02-28 08:46 30 *********** 72 2021-02-28 08:47 30 *********** 73 2021-02-28 08:48 53 ********************************** ... ..( 2 skipped). .. ********************************** 76 2021-02-28 08:51 53 ********************************** 77 2021-02-28 08:52 54 *********************************** ... ..( 8 skipped). .. *********************************** 86 2021-02-28 09:01 54 *********************************** 87 2021-02-28 09:02 55 ************************************ ... ..( 15 skipped). .. ************************************ 103 2021-02-28 09:18 55 ************************************ 104 2021-02-28 09:19 56 ************************************* ... ..( 8 skipped). .. ************************************* 113 2021-02-28 09:28 56 ************************************* 114 2021-02-28 09:29 55 ************************************ ... ..( 5 skipped). .. ************************************ 120 2021-02-28 09:35 55 ************************************ 121 2021-02-28 09:36 56 ************************************* ... ..( 13 skipped). .. ************************************* 7 2021-02-28 09:50 56 ************************************* 8 2021-02-28 09:51 57 ************************************** ... ..( 3 skipped). .. ************************************** 12 2021-02-28 09:55 57 ************************************** 13 2021-02-28 09:56 51 ******************************** SMART WRITE LOG does not return COUNT and LBA_LOW register SCT (Get) Error Recovery Control command failed Device Statistics (SMART Log 0x04) Page Offset Size Value Flags Description ATA_SMART_READ_LOG failed: Undefined error: 0 Read Device Statistics pages 0x00-0x06 failed Pending Defects log (GP Log 0x0c) not supported ATA_READ_LOG_EXT (addr=0x11:0x00, page=0, n=1) failed: 48-bit ATA commands not implemented Read SATA Phy Event Counters failed