smartctl 7.2 2020-12-30 r5155 [armv7l-linux-5.4.0-1028-raspi] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: SAMSUNG SpinPoint T166 Device Model: SAMSUNG HD501LJ Serial Number: S0MUJ1FPB87260 LU WWN Device Id: 5 0000f0 01bb87260 Firmware Version: CR100-12 User Capacity: 500'107'862'016 bytes [500 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 3b SATA Version is: SATA 2.5, 3.0 Gb/s Local Time is: Thu Feb 11 10:39:38 2021 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Unknown === START OF READ SMART DATA SECTION === SMART Status not supported: Incomplete response, ATA output registers missing SMART overall-health self-assessment test result: PASSED Warning: This result is based on an Attribute check. General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 9069) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 155) minutes. SCT capabilities: (0x003f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-- 100 100 051 - 0 3 Spin_Up_Time POS--- 100 100 015 - 7552 4 Start_Stop_Count -O--CK 084 084 000 - 17112 5 Reallocated_Sector_Ct PO--CK 100 100 010 - 1 7 Seek_Error_Rate POSR-- 253 253 051 - 0 8 Seek_Time_Performance P-S--K 253 253 015 - 0 9 Power_On_Hours -O--CK 100 100 000 - 15684 10 Spin_Retry_Count PO--CK 253 253 051 - 0 11 Calibration_Retry_Count -O--C- 253 253 000 - 0 12 Power_Cycle_Count -O--CK 096 096 000 - 4766 13 Read_Soft_Error_Rate -OSR-- 100 100 000 - 3071758 187 Reported_Uncorrect -O--CK 253 253 000 - 0 188 Command_Timeout -O--CK 253 253 000 - 0 190 Airflow_Temperature_Cel -O---K 060 049 000 - 40 194 Temperature_Celsius -O---K 118 082 000 - 40 195 Hardware_ECC_Recovered -O-RC- 100 100 000 - 3071758 196 Reallocated_Event_Count -O--CK 100 100 000 - 1 197 Total_Pending_Sectors -O--C- 253 253 000 - 0 198 Offline_Uncorrectable ----CK 253 253 000 - 0 199 UDMA_CRC_Error_Count -OSRCK 200 200 000 - 0 200 Multi_Zone_Error_Rate -O-R-- 100 100 000 - 0 201 Soft_Read_Error_Rate -O-R-- 253 100 000 - 0 202 Data_Address_Mark_Errs -O--CK 100 100 000 - 34 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 2 Comprehensive SMART error log 0x03 GPL R/O 2 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x09 GPL,SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (2 sectors) No Errors Logged SMART Extended Self-test Log (GP Log 0x07) not supported SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Extended offline Completed without error 00% 14018 - # 2 Short offline Completed without error 00% 13932 - # 3 Extended offline Completed without error 00% 13911 - # 4 Short offline Completed without error 00% 9 - SMART Selective self-test log data structure revision number 0 Note: revision number not 1 implies that no selective self-test has ever been run SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 40 Celsius Power Cycle Min/Max Temperature: 14/41 Celsius Lifetime Min/Max Temperature: 6/52 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: -4/72 Celsius Min/Max Temperature Limit: -9/77 Celsius Temperature History Size (Index): 128 (66) Index Estimated Time Temperature Celsius 67 2021-02-11 08:32 20 * 68 2021-02-11 08:33 20 * 69 2021-02-11 08:34 21 ** 70 2021-02-11 08:35 22 *** 71 2021-02-11 08:36 23 **** 72 2021-02-11 08:37 23 **** 73 2021-02-11 08:38 24 ***** 74 2021-02-11 08:39 24 ***** 75 2021-02-11 08:40 25 ****** 76 2021-02-11 08:41 26 ******* 77 2021-02-11 08:42 26 ******* 78 2021-02-11 08:43 27 ******** 79 2021-02-11 08:44 27 ******** 80 2021-02-11 08:45 28 ********* 81 2021-02-11 08:46 28 ********* 82 2021-02-11 08:47 28 ********* 83 2021-02-11 08:48 29 ********** 84 2021-02-11 08:49 29 ********** 85 2021-02-11 08:50 29 ********** 86 2021-02-11 08:51 30 *********** 87 2021-02-11 08:52 30 *********** 88 2021-02-11 08:53 30 *********** 89 2021-02-11 08:54 31 ************ 90 2021-02-11 08:55 31 ************ 91 2021-02-11 08:56 31 ************ 92 2021-02-11 08:57 32 ************* ... ..( 2 skipped). .. ************* 95 2021-02-11 09:00 32 ************* 96 2021-02-11 09:01 33 ************** 97 2021-02-11 09:02 33 ************** 98 2021-02-11 09:03 33 ************** 99 2021-02-11 09:04 35 **************** ... ..( 4 skipped). .. **************** 104 2021-02-11 09:09 35 **************** 105 2021-02-11 09:10 36 ***************** ... ..( 4 skipped). .. ***************** 110 2021-02-11 09:15 36 ***************** 111 2021-02-11 09:16 37 ****************** ... ..( 7 skipped). .. ****************** 119 2021-02-11 09:24 37 ****************** 120 2021-02-11 09:25 38 ******************* ... ..( 9 skipped). .. ******************* 2 2021-02-11 09:35 38 ******************* 3 2021-02-11 09:36 39 ******************** ... ..( 39 skipped). .. ******************** 43 2021-02-11 10:16 39 ******************** 44 2021-02-11 10:17 40 ********************* ... ..( 17 skipped). .. ********************* 62 2021-02-11 10:35 40 ********************* 63 2021-02-11 10:36 41 ********************** 64 2021-02-11 10:37 40 ********************* 65 2021-02-11 10:38 40 ********************* 66 2021-02-11 10:39 19 - SMART WRITE LOG does not return COUNT and LBA_LOW register SCT (Get) Error Recovery Control command failed Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 0 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 2 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0010 2 0 R_ERR response for host-to-device data FIS, non-CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x0013 2 0 R_ERR response for host-to-device non-data FIS, non-CRC 0x8001 2 0 Vendor specific