smartctl 7.0 2019-05-21 r4917 [aarch64-linux-5.3.18-lp152.57-default] (SUSE RPM) Copyright (C) 2002-18, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: Hitachi HTS545025B9SA02 Serial Number: 100508PBL2003SK1818V LU WWN Device Id: 5 000cca 5f3ead911 Firmware Version: PB2AC60W User Capacity: 250,059,350,016 bytes [250 GB] Sector Size: 512 bytes logical/physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 1.5 Gb/s Local Time is: Thu Dec 10 02:11:17 2020 CST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 645) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 83) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 112 112 040 - 4262 3 Spin_Up_Time POS--- 209 209 033 - 1 4 Start_Stop_Count -O--C- 099 099 000 - 3052 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 113 113 040 - 35 9 Power_On_Hours -O--C- 097 097 000 - 1417 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 099 099 000 - 2028 160 Unknown_Attribute -O--CK 100 100 000 - 0 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 665719930880 192 Power-Off_Retract_Count -O--CK 100 100 000 - 8593276989 193 Load_Cycle_Count -O--C- 089 089 000 - 119781 194 Temperature_Celsius -O---- 152 152 000 - 36 (Min/Max 16/48) 195 Hardware_ECC_Recovered -O-R-- 100 100 000 - 0 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 254 Free_Fall_Sensor -O--CK 098 098 000 - 629 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa2 SL VS 1 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 1394 - # 2 Extended offline Aborted by host 80% 1371 - # 3 Short offline Completed without error 00% 1358 - # 4 Short offline Completed without error 00% 1242 - # 5 Short offline Completed without error 00% 1208 - # 6 Short offline Completed without error 00% 1170 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 36 Celsius Power Cycle Min/Max Temperature: 34/37 Celsius Lifetime Min/Max Temperature: 16/48 Celsius Specified Max Operating Temperature: 32 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 5/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 478 (25) Index Estimated Time Temperature Celsius 26 2020-12-09 18:14 36 ***************** ... ..( 13 skipped). .. ***************** 40 2020-12-09 18:28 36 ***************** 41 2020-12-09 18:29 37 ****************** ... ..(207 skipped). .. ****************** 249 2020-12-09 21:57 37 ****************** 250 2020-12-09 21:58 36 ***************** ... ..( 6 skipped). .. ***************** 257 2020-12-09 22:05 36 ***************** 258 2020-12-09 22:06 37 ****************** ... ..( 19 skipped). .. ****************** 278 2020-12-09 22:26 37 ****************** 279 2020-12-09 22:27 36 ***************** ... ..( 2 skipped). .. ***************** 282 2020-12-09 22:30 36 ***************** 283 2020-12-09 22:31 37 ****************** 284 2020-12-09 22:32 36 ***************** ... ..( 24 skipped). .. ***************** 309 2020-12-09 22:57 36 ***************** 310 2020-12-09 22:58 37 ****************** 311 2020-12-09 22:59 36 ***************** ... ..( 2 skipped). .. ***************** 314 2020-12-09 23:02 36 ***************** 315 2020-12-09 23:03 37 ****************** 316 2020-12-09 23:04 36 ***************** 317 2020-12-09 23:05 36 ***************** 318 2020-12-09 23:06 36 ***************** 319 2020-12-09 23:07 37 ****************** ... ..( 3 skipped). .. ****************** 323 2020-12-09 23:11 37 ****************** 324 2020-12-09 23:12 36 ***************** 325 2020-12-09 23:13 36 ***************** 326 2020-12-09 23:14 36 ***************** 327 2020-12-09 23:15 37 ****************** 328 2020-12-09 23:16 37 ****************** 329 2020-12-09 23:17 36 ***************** ... ..(173 skipped). .. ***************** 25 2020-12-10 02:11 36 ***************** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0009 2 2 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 2 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS