Custom Query (1095 matches)

Filters
 
Or
 
  
 
Columns

Show under each result:


Results (40 - 42 of 1095)

Ticket Resolution Summary Owner Reporter
#40 fixed smartctl --test when a test is already running causes it to abort Christian Franke Giuseppe Iuculano
Description

Hi,

I'm forwarding a bug reported by a Debian user.

smartctl can be used to execute a test on a drive already running another test. In my case, I ran a short test on a drive already running a long test. I was not aware that SMART could only handle 1 test at a time. Apparently, SMART can't resume aborted tests.

smartctl's behavior in this case seems to be to execute the newly requested test without caring about the already one. The worst problem with this is loss of time, as in my scenario. I see two options: running the newly requested test after the currently running one is finished, or prompt for what to do.

#41 invalid smartd: internal error in MailWarning(): cfg.mailwarn->emailfreq=0 somebody Giuseppe Iuculano
Description

Hi,

I'm forwarding a bug reported by a Debian user. Version: smartctl 5.39 2009-12-09 r2995 [i686-pc-linux-gnu] (local build)

Smartd logs internal error along with the notification of a failing hard disk.

From /var/log/syslog

-8<- Jan 12 13:42:11 hanuri smartd[9147]: Device: /dev/sdc, 5 Currently unreadable (pending) sectors Jan 12 13:42:11 hanuri smartd[9147]: internal error in MailWarning?(): cfg.mailwarn->emailfreq=0 -8<-

/etc/smartd.conf has: -8<- /dev/sda -d ata -I 194 -I 190 /dev/sdb -d ata -I 194 -I 190 /dev/sdc -d ata -I 194 -I 190 /dev/sdd -d ata -I 194 -I 190 /dev/sde -d ata -I 194 -I 190 /dev/sdf -d ata -I 194 -I 190 -8<-

#42 wontfix Subzero temperature somebody rhn_mk1
Description

Smartctl seems to treat temperature as an unsigned integer. That leads to weird values (~65K) when the temperature is below 0. I don't know if it's SMART's official interpretation of temperature, but I think it would be wise to assume no drives run at 65000 and some do run at <0. Usually it's not inended, but accidents happen...

Note: See TracQuery for help on using queries.