Ticket #1365: smartctl-HGST-HUS728T8TALE6L4.txt

File smartctl-HGST-HUS728T8TALE6L4.txt, 9.8 KB (added by Cmdr_Zod, 4 years ago)
Line 
1smartctl 6.6 2017-11-05 r4594 [x86_64-linux-4.18.0-193.14.2.el8_2.x86_64] (local build)
2Copyright (C) 2002-17, Bruce Allen, Christian Franke, www.smartmontools.org
3
4=== START OF INFORMATION SECTION ===
5Device Model: HGST HUS728T8TALE6L4
6Firmware Version: V8GNW460
7User Capacity: 8,001,563,222,016 bytes [8.00 TB]
8Sector Sizes: 512 bytes logical, 4096 bytes physical
9Rotation Rate: 7200 rpm
10Form Factor: 3.5 inches
11Device is: Not in smartctl database [for details use: -P showall]
12ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 4
13SATA Version is: SATA 3.2, 6.0 Gb/s (current: 6.0 Gb/s)
14Local Time is: Tue Sep 1 16:32:48 2020 CEST
15SMART support is: Available - device has SMART capability.
16SMART support is: Enabled
17AAM feature is: Unavailable
18APM feature is: Disabled
19Rd look-ahead is: Enabled
20Write cache is: Enabled
21DSN feature is: Unavailable
22ATA Security is: Disabled, frozen [SEC2]
23Wt Cache Reorder: Enabled
24
25=== START OF READ SMART DATA SECTION ===
26SMART overall-health self-assessment test result: PASSED
27
28General SMART Values:
29Offline data collection status: (0x80) Offline data collection activity
30 was never started.
31 Auto Offline Data Collection: Enabled.
32Self-test execution status: ( 0) The previous self-test routine completed
33 without error or no self-test has ever
34 been run.
35Total time to complete Offline
36data collection: ( 87) seconds.
37Offline data collection
38capabilities: (0x5b) SMART execute Offline immediate.
39 Auto Offline data collection on/off support.
40 Suspend Offline collection upon new
41 command.
42 Offline surface scan supported.
43 Self-test supported.
44 No Conveyance Self-test supported.
45 Selective Self-test supported.
46SMART capabilities: (0x0003) Saves SMART data before entering
47 power-saving mode.
48 Supports SMART auto save timer.
49Error logging capability: (0x01) Error logging supported.
50 General Purpose Logging supported.
51Short self-test routine
52recommended polling time: ( 2) minutes.
53Extended self-test routine
54recommended polling time: ( 907) minutes.
55SCT capabilities: (0x003d) SCT Status supported.
56 SCT Error Recovery Control supported.
57 SCT Feature Control supported.
58 SCT Data Table supported.
59
60SMART Attributes Data Structure revision number: 16
61Vendor Specific SMART Attributes with Thresholds:
62ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE
63 1 Raw_Read_Error_Rate PO-R-- 100 100 016 - 0
64 2 Throughput_Performance P-S--- 132 132 054 - 96
65 3 Spin_Up_Time POS--- 100 100 024 - 0
66 4 Start_Stop_Count -O--C- 100 100 000 - 5
67 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0
68 7 Seek_Error_Rate PO-R-- 100 100 067 - 0
69 8 Seek_Time_Performance P-S--- 128 128 020 - 18
70 9 Power_On_Hours -O--C- 100 100 000 - 29
71 10 Spin_Retry_Count PO--C- 100 100 060 - 0
72 12 Power_Cycle_Count -O--CK 100 100 000 - 5
73192 Power-Off_Retract_Count -O--CK 100 100 000 - 8
74193 Load_Cycle_Count -O--C- 100 100 000 - 8
75194 Temperature_Celsius -O---- 181 181 000 - 33 (Min/Max 25/40)
76196 Reallocated_Event_Count -O--CK 100 100 000 - 0
77197 Current_Pending_Sector -O---K 100 100 000 - 0
78198 Offline_Uncorrectable ---R-- 100 100 000 - 0
79199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0
80 ||||||_ K auto-keep
81 |||||__ C event count
82 ||||___ R error rate
83 |||____ S speed/performance
84 ||_____ O updated online
85 |______ P prefailure warning
86
87General Purpose Log Directory Version 1
88SMART Log Directory Version 1 [multi-sector log support]
89Address Access R/W Size Description
900x00 GPL,SL R/O 1 Log Directory
910x01 SL R/O 1 Summary SMART error log
920x02 SL R/O 1 Comprehensive SMART error log
930x03 GPL R/O 1 Ext. Comprehensive SMART error log
940x04 GPL R/O 256 Device Statistics log
950x04 SL R/O 255 Device Statistics log
960x06 SL R/O 1 SMART self-test log
970x07 GPL R/O 1 Extended self-test log
980x08 GPL R/O 2 Power Conditions log
990x09 SL R/W 1 Selective self-test log
1000x0c GPL R/O 5501 Pending Defects log
1010x10 GPL R/O 1 NCQ Command Error log
1020x11 GPL R/O 1 SATA Phy Event Counters log
1030x12 GPL R/O 1 SATA NCQ Non-Data log
1040x13 GPL R/O 1 SATA NCQ Send and Receive log
1050x15 GPL R/W 1 Rebuild Assist log
1060x21 GPL R/O 1 Write stream error log
1070x22 GPL R/O 1 Read stream error log
1080x24 GPL R/O 256 Current Device Internal Status Data log
1090x25 GPL R/O 256 Saved Device Internal Status Data log
1100x2f GPL - 1 Set Sector Configuration
1110x30 GPL,SL R/O 9 IDENTIFY DEVICE data log
1120x80-0x9f GPL,SL R/W 16 Host vendor specific log
1130xe0 GPL,SL R/W 1 SCT Command/Status
1140xe1 GPL,SL R/W 1 SCT Data Transfer
115
116SMART Extended Comprehensive Error Log Version: 1 (1 sectors)
117No Errors Logged
118
119SMART Extended Self-test Log Version: 1 (1 sectors)
120Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
121# 1 Short offline Completed without error 00% 5 -
122
123SMART Selective self-test log data structure revision number 1
124 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
125 1 0 0 Not_testing
126 2 0 0 Not_testing
127 3 0 0 Not_testing
128 4 0 0 Not_testing
129 5 0 0 Not_testing
130Selective self-test flags (0x0):
131 After scanning selected spans, do NOT read-scan remainder of disk.
132If Selective self-test is pending on power-up, resume after 0 minute delay.
133
134SCT Status Version: 3
135SCT Version (vendor specific): 256 (0x0100)
136SCT Support Level: 0
137Device State: Active (0)
138Current Temperature: 33 Celsius
139Power Cycle Min/Max Temperature: 33/34 Celsius
140Lifetime Min/Max Temperature: 25/40 Celsius
141Under/Over Temperature Limit Count: 0/0
142
143SCT Temperature History Version: 2
144Temperature Sampling Period: 1 minute
145Temperature Logging Interval: 1 minute
146Min/Max recommended Temperature: 0/60 Celsius
147Min/Max Temperature Limit: -40/70 Celsius
148Temperature History Size (Index): 128 (115)
149
150Index Estimated Time Temperature Celsius
151 116 2020-09-01 14:25 37 ******************
152 ... ..( 55 skipped). .. ******************
153 44 2020-09-01 15:21 37 ******************
154 45 2020-09-01 15:22 38 *******************
155 46 2020-09-01 15:23 38 *******************
156 47 2020-09-01 15:24 38 *******************
157 48 2020-09-01 15:25 37 ******************
158 49 2020-09-01 15:26 38 *******************
159 ... ..( 30 skipped). .. *******************
160 80 2020-09-01 15:57 38 *******************
161 81 2020-09-01 15:58 37 ******************
162 82 2020-09-01 15:59 37 ******************
163 83 2020-09-01 16:00 37 ******************
164 84 2020-09-01 16:01 34 ***************
165 ... ..( 9 skipped). .. ***************
166 94 2020-09-01 16:11 34 ***************
167 95 2020-09-01 16:12 33 **************
168 96 2020-09-01 16:13 34 ***************
169 97 2020-09-01 16:14 34 ***************
170 98 2020-09-01 16:15 34 ***************
171 99 2020-09-01 16:16 33 **************
172 100 2020-09-01 16:17 33 **************
173 101 2020-09-01 16:18 34 ***************
174 ... ..( 6 skipped). .. ***************
175 108 2020-09-01 16:25 34 ***************
176 109 2020-09-01 16:26 33 **************
177 ... ..( 4 skipped). .. **************
178 114 2020-09-01 16:31 33 **************
179 115 2020-09-01 16:32 37 ******************
180
181SCT Error Recovery Control:
182 Read: Disabled
183 Write: Disabled
184
185Device Statistics (GP/SMART Log 0x04) not supported
186
187Pending Defects log (GP Log 0x0c) supported [please try: '-l defects']
188
189SATA Phy Event Counters (GP Log 0x11)
190ID Size Value Description
1910x0001 2 0 Command failed due to ICRC error
1920x0002 2 0 R_ERR response for data FIS
1930x0003 2 0 R_ERR response for device-to-host data FIS
1940x0004 2 0 R_ERR response for host-to-device data FIS
1950x0005 2 0 R_ERR response for non-data FIS
1960x0006 2 0 R_ERR response for device-to-host non-data FIS
1970x0007 2 0 R_ERR response for host-to-device non-data FIS
1980x0008 2 0 Device-to-host non-data FIS retries
1990x0009 2 2 Transition from drive PhyRdy to drive PhyNRdy
2000x000a 2 3 Device-to-host register FISes sent due to a COMRESET
2010x000b 2 0 CRC errors within host-to-device FIS
2020x000d 2 0 Non-CRC errors within host-to-device FIS
203