Ticket #1033: smartctl-WDC-WD8003FRYZ-01JPDB1.txt

File smartctl-WDC-WD8003FRYZ-01JPDB1.txt, 9.7 KB (added by Christian, 6 years ago)
Line 
1smartctl 6.6 2016-05-31 r4324 [armv7l-linux-4.14.34-1-osmc] (local build)
2Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org
3
4=== START OF INFORMATION SECTION ===
5Device Model: WDC WD8003FRYZ-01JPDB1
6Firmware Version: 01.01H02
7User Capacity: 8.001.563.222.016 bytes [8,00 TB]
8Sector Sizes: 512 bytes logical, 4096 bytes physical
9Rotation Rate: 7200 rpm
10Form Factor: 3.5 inches
11Device is: Not in smartctl database [for details use: -P showall]
12ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 4
13SATA Version is: SATA 3.2, 6.0 Gb/s (current: 6.0 Gb/s)
14Local Time is: Mon May 21 15:38:46 2018 CEST
15SMART support is: Available - device has SMART capability.
16SMART support is: Enabled
17AAM feature is: Unavailable
18APM level is: 254 (maximum performance)
19Rd look-ahead is: Enabled
20Write cache is: Enabled
21ATA Security is: Disabled, NOT FROZEN [SEC1]
22Wt Cache Reorder: Unknown
23
24=== START OF READ SMART DATA SECTION ===
25SMART Status not supported: Incomplete response, ATA output registers missing
26SMART overall-health self-assessment test result: PASSED
27Warning: This result is based on an Attribute check.
28
29General SMART Values:
30Offline data collection status: (0x82) Offline data collection activity
31 was completed without error.
32 Auto Offline Data Collection: Enabled.
33Self-test execution status: ( 0) The previous self-test routine completed
34 without error or no self-test has ever
35 been run.
36Total time to complete Offline
37data collection: ( 93) seconds.
38Offline data collection
39capabilities: (0x5b) SMART execute Offline immediate.
40 Auto Offline data collection on/off support.
41 Suspend Offline collection upon new
42 command.
43 Offline surface scan supported.
44 Self-test supported.
45 No Conveyance Self-test supported.
46 Selective Self-test supported.
47SMART capabilities: (0x0003) Saves SMART data before entering
48 power-saving mode.
49 Supports SMART auto save timer.
50Error logging capability: (0x01) Error logging supported.
51 General Purpose Logging supported.
52Short self-test routine
53recommended polling time: ( 2) minutes.
54Extended self-test routine
55recommended polling time: (1096) minutes.
56SCT capabilities: (0x003d) SCT Status supported.
57 SCT Error Recovery Control supported.
58 SCT Feature Control supported.
59 SCT Data Table supported.
60
61SMART Attributes Data Structure revision number: 16
62Vendor Specific SMART Attributes with Thresholds:
63ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE
64 1 Raw_Read_Error_Rate PO-R-- 100 100 016 - 0
65 2 Throughput_Performance P-S--- 130 130 054 - 108
66 3 Spin_Up_Time POS--- 145 145 024 - 453 (Average 453)
67 4 Start_Stop_Count -O--C- 100 100 000 - 44
68 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0
69 7 Seek_Error_Rate PO-R-- 100 100 067 - 0
70 8 Seek_Time_Performance P-S--- 128 128 020 - 18
71 9 Power_On_Hours -O--C- 100 100 000 - 102
72 10 Spin_Retry_Count PO--C- 100 100 060 - 0
73 12 Power_Cycle_Count -O--CK 100 100 000 - 7
74 22 Unknown_Attribute PO---K 100 100 025 - 100
75192 Power-Off_Retract_Count -O--CK 100 100 000 - 46
76193 Load_Cycle_Count -O--C- 100 100 000 - 46
77194 Temperature_Celsius -O---- 206 206 000 - 29 (Min/Max 16/31)
78196 Reallocated_Event_Count -O--CK 100 100 000 - 0
79197 Current_Pending_Sector -O---K 100 100 000 - 0
80198 Offline_Uncorrectable ---R-- 100 100 000 - 0
81199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0
82 ||||||_ K auto-keep
83 |||||__ C event count
84 ||||___ R error rate
85 |||____ S speed/performance
86 ||_____ O updated online
87 |______ P prefailure warning
88
89General Purpose Log Directory Version 1
90SMART Log Directory Version 1 [multi-sector log support]
91Address Access R/W Size Description
920x00 GPL,SL R/O 1 Log Directory
930x01 SL R/O 1 Summary SMART error log
940x02 SL R/O 1 Comprehensive SMART error log
950x03 GPL R/O 1 Ext. Comprehensive SMART error log
960x04 GPL R/O 256 Device Statistics log
970x04 SL R/O 255 Device Statistics log
980x06 SL R/O 1 SMART self-test log
990x07 GPL R/O 1 Extended self-test log
1000x08 GPL R/O 2 Power Conditions log
1010x09 SL R/W 1 Selective self-test log
1020x0c GPL R/O 5501 Pending Defects log
1030x10 GPL R/O 1 SATA NCQ Queued Error log
1040x11 GPL R/O 1 SATA Phy Event Counters log
1050x12 GPL R/O 1 SATA NCQ NON-DATA log
1060x13 GPL R/O 1 SATA NCQ Send and Receive log
1070x15 GPL R/W 1 SATA Rebuild Assist log
1080x21 GPL R/O 1 Write stream error log
1090x22 GPL R/O 1 Read stream error log
1100x24 GPL R/O 256 Current Device Internal Status Data log
1110x25 GPL R/O 256 Saved Device Internal Status Data log
1120x30 GPL,SL R/O 9 IDENTIFY DEVICE data log
1130x80-0x9f GPL,SL R/W 16 Host vendor specific log
1140xe0 GPL,SL R/W 1 SCT Command/Status
1150xe1 GPL,SL R/W 1 SCT Data Transfer
116
117SMART Extended Comprehensive Error Log Version: 1 (1 sectors)
118No Errors Logged
119
120SMART Extended Self-test Log Version: 1 (1 sectors)
121Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
122# 1 Short offline Completed without error 00% 102 -
123# 2 Short offline Completed without error 00% 101 -
124
125SMART Selective self-test log data structure revision number 1
126 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
127 1 0 0 Not_testing
128 2 0 0 Not_testing
129 3 0 0 Not_testing
130 4 0 0 Not_testing
131 5 0 0 Not_testing
132Selective self-test flags (0x0):
133 After scanning selected spans, do NOT read-scan remainder of disk.
134If Selective self-test is pending on power-up, resume after 0 minute delay.
135
136SCT Status Version: 3
137SCT Version (vendor specific): 256 (0x0100)
138SCT Support Level: 0
139Device State: Active (0)
140Current Temperature: 29 Celsius
141Power Cycle Min/Max Temperature: 22/31 Celsius
142Lifetime Min/Max Temperature: 16/31 Celsius
143Under/Over Temperature Limit Count: 0/0
144
145SCT Temperature History Version: 2
146Temperature Sampling Period: 1 minute
147Temperature Logging Interval: 1 minute
148Min/Max recommended Temperature: 0/60 Celsius
149Min/Max Temperature Limit: -40/70 Celsius
150Temperature History Size (Index): 128 (4)
151
152Index Estimated Time Temperature Celsius
153 5 2018-05-21 13:31 25 ******
154 ... ..( 57 skipped). .. ******
155 63 2018-05-21 14:29 25 ******
156 64 2018-05-21 14:30 26 *******
157 65 2018-05-21 14:31 26 *******
158 66 2018-05-21 14:32 26 *******
159 67 2018-05-21 14:33 27 ********
160 68 2018-05-21 14:34 28 *********
161 ... ..( 3 skipped). .. *********
162 72 2018-05-21 14:38 28 *********
163 73 2018-05-21 14:39 29 **********
164 ... ..( 4 skipped). .. **********
165 78 2018-05-21 14:44 29 **********
166 79 2018-05-21 14:45 30 ***********
167 80 2018-05-21 14:46 30 ***********
168 81 2018-05-21 14:47 29 **********
169 ... ..( 2 skipped). .. **********
170 84 2018-05-21 14:50 29 **********
171 85 2018-05-21 14:51 28 *********
172 ... ..( 3 skipped). .. *********
173 89 2018-05-21 14:55 28 *********
174 90 2018-05-21 14:56 27 ********
175 ... ..( 6 skipped). .. ********
176 97 2018-05-21 15:03 27 ********
177 98 2018-05-21 15:04 26 *******
178 ... ..( 6 skipped). .. *******
179 105 2018-05-21 15:11 26 *******
180 106 2018-05-21 15:12 27 ********
181 107 2018-05-21 15:13 27 ********
182 108 2018-05-21 15:14 28 *********
183 ... ..( 2 skipped). .. *********
184 111 2018-05-21 15:17 28 *********
185 112 2018-05-21 15:18 29 **********
186 ... ..( 4 skipped). .. **********
187 117 2018-05-21 15:23 29 **********
188 118 2018-05-21 15:24 30 ***********
189 119 2018-05-21 15:25 29 **********
190 ... ..( 2 skipped). .. **********
191 122 2018-05-21 15:28 29 **********
192 123 2018-05-21 15:29 28 *********
193 ... ..( 7 skipped). .. *********
194 3 2018-05-21 15:37 28 *********
195 4 2018-05-21 15:38 25 ******
196
197SMART WRITE LOG does not return COUNT and LBA_LOW register
198SCT (Get) Error Recovery Control command failed
199
200Device Statistics (GP/SMART Log 0x04) not supported
201
202SATA Phy Event Counters (GP Log 0x11)
203ID Size Value Description
2040x0001 2 0 Command failed due to ICRC error
2050x0002 2 0 R_ERR response for data FIS
2060x0003 2 0 R_ERR response for device-to-host data FIS
2070x0004 2 0 R_ERR response for host-to-device data FIS
2080x0005 2 0 R_ERR response for non-data FIS
2090x0006 2 0 R_ERR response for device-to-host non-data FIS
2100x0007 2 0 R_ERR response for host-to-device non-data FIS
2110x0008 2 0 Device-to-host non-data FIS retries
2120x0009 2 112 Transition from drive PhyRdy to drive PhyNRdy
2130x000a 2 112 Device-to-host register FISes sent due to a COMRESET
2140x000b 2 0 CRC errors within host-to-device FIS
2150x000d 2 0 Non-CRC errors within host-to-device FIS
216